Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008HHR LT, 2.4 P, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 632 (POWER STEERING SYSTEM)
2008 Chevrolet HHR LT, 2.4 P, Automatic
Section 632 (Power Steering System)
2008 Chevrolet HHR LT, 2.4 P, AutomaticSECTION Section 632 (Power Steering System)
WARNING: This page is about a different car, the 2011 Chevrolet HHR. However, it is still accessible from the selected car via links, so may be relevant.
- Specifications
- Wiring Schematics
- Diagnostic Information and Procedures
- Diagnostic Code Index
- DTC C0000
- DTC C0176
- DTC C0460
- DTC C0475
- DTC C0545
- DTC C0561
- DTC C056D
- DTC C056E
- DTC C0845
- Diagnostic Instructions
- DTC Descriptors
- Diagnostic Fault Information
- Circuit/System Description
- Conditions for Running the DTC
- Conditions for Setting the DTC
- Action Taken When the DTC Sets
- Conditions for Clearing the DTC
- Reference Information
- Circuit/System Verification
- Circuit/System Testing
- Repair Instructions
- Symptoms - Power Steering System (Electronic Power Steering)
- Rattle, Clunk, or Shudder Noise from the Power Steering System
- Increase in Effort While Turning Steering Wheel
- Poor Return of Steering Wheel
- Steering Wheel Surges/Jerks While Turning
- Repair Instructions
- Description and Operation
- Special Tools and Equipment
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.