Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008HHR LT, 2.4 P, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 487 (INSTRUMENT PANEL TRIM AND CONSOLE TRIM)
2008 Chevrolet HHR LT, 2.4 P, Automatic
Section 487 (Instrument Panel Trim And Console Trim)
2008 Chevrolet HHR LT, 2.4 P, AutomaticSECTION Section 487 (Instrument Panel Trim And Console Trim)
WARNING: This page is about a different car, the 2011 GMC Canyon and 2011 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
- Specifications
- Repair Instructions
- Instrument Panel Lower Center Trim Replacement
- Driver Knee Bolster Panel Replacement
- Knee Bolster Replacement
- Instrument Panel Accessory Trim Plate Replacement
- Instrument Panel Cluster Trim Plate Bezel Replacement
- Radio Opening Cover Replacement
- Instrument Panel Storage Compartment Replacement
- Instrument Panel Compartment Door Replacement
- Instrument Panel Compartment Door Latch Replacement
- Instrument Panel Assembly Replacement
- Instrument Panel Carrier Replacement
- Front Floor Console Stowage Tray Replacement
- Front Floor Console Compartment Door Hinge Replacement
- Console Shift Lever Bezel Replacement
- Console Replacement (Large w/Manual or Auto Transmission)
- Console Replacement (Small w/Manual Transmission)
- Front Floor Console Armrest Replacement
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.