Installation Procedure

2008 Chevrolet HHR LT, 2.4 P, AutomaticSECTION Installation Procedure
WARNING: This page is about a different car, the 2011 GMC Canyon and 2011 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Starter Motor
    GM1313646Courtesy of GENERAL MOTORS CORP.
  1. Position the starter motor (3) over the stud (2).
  2. CAUTION: Refer to Fastener Caution .
  3. Install the starter motor mounting nut (1) and bolt (4) and tighten to 50 N.m (37 lb ft).
  4. Fig 2: Locating Positive Battery Cable
    GM1313639Courtesy of GENERAL MOTORS CORP.
  5. Connect the battery positive cable (2) to the starter and install the starter terminal nut (1).

    Tighten the nut to 9 N.m (80 lb in).

  6. Connect the lead (4) to the starter solenoid and install the starter solenoid S terminal nut (3).

    Tighten the nut to 3.5 N.m (31 lb in).

  7. Install the intake manifold. Refer to Intake Manifold Replacement for the 2.9L engine or Intake Manifold Replacement for the 3.7L engine.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.