HFL Switch Test

2008 Chevrolet HHR LT, 2.4 P, AutomaticSECTION HFL Switch Test
WARNING: This page is about a different car, the 2011 Honda Insight and 2010 Honda Insight. However, it is still accessible from the selected car via links, so may be relevant.

SRS components are located in this area. Review the SRS component location (see COMPONENT LOCATION INDEX ), and the precautions and procedures (see PRECAUTIONS AND PROCEDURES ) in the SRS section before doing repairs or service.

  1. Remove the HFL-navigation voice control switch (see VOICE CONTROL SWITCH TEST ).
    Fig 1: Identifying HFL-Navigation Voice Control Switch Connector Terminals
    G06432041Courtesy of AMERICAN HONDA MOTOR CO., INC.
  2. Measure the resistance between terminals No. 3 and No. 4 in each switch position according to the table.

    HFL SwitchΒ 

    RESISTANCE REFERENCE CHART

    Position Resistance
    No button pressed About 1 k Ξ©
    HFL Talk button pressed About 185 Ξ©
    HFL Back button pressed About 45 Ξ©
  3. If the resistance is not as specified, replace the HFL-navigation voice control switch (see VOICE CONTROL SWITCH TEST ).
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.