Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2008HHR LT, 2.4 P, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 217 (NAVIGATION SYSTEM)VOICE CONTROL SWITCH TEST

2008 Chevrolet HHR LT, 2.4 P, Automatic

Voice Control Switch Test

2008 Chevrolet HHR LT, 2.4 P, AutomaticSECTION Voice Control Switch Test

WARNING: This page is about a different car, the 2011 Honda Insight and 2010 Honda Insight. However, it is still accessible from the selected car via links, so may be relevant.

SRS components are located in this area. Review the SRS component location (see COMPONENT LOCATION INDEX ), and the precautions and procedures (see PRECAUTIONS AND PROCEDURES ) in the SRS section before doing repairs or service.

Remove the HFL-navigation voice control switch (see VOICE CONTROL SWITCH TEST ).

Fig 1: Identifying HFL-Navigation Voice Control Switch Connector Terminals
Courtesy of AMERICAN HONDA MOTOR CO., INC.

Measure the resistance between terminals No. 2 and No. 4 in each switch position according to the table.

RESISTANCE CHART

Position	Resistance
No button pressed	About 10 kΩ
Navigation TALK button	About 2.2 kΩ
Navigation BACK button	About 650 Ω

If the resistance is not as specified, replace the HFL-navigation voice control switch (see VOICE CONTROL SWITCH TEST ).

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.