SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 636 (INSTRUMENT PANEL, GAGES, AND CONSOLE)REPAIR INSTRUCTIONSINSTRUMENT PANEL (I/P) EXTENSION REPLACEMENT (PRO)REMOVAL PROCEDURE
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6

Removal Procedure

2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Removal Procedure
WARNING: This page is about a different car, the 2003 GMC Sierra, 2003 GMC Cab & Chassis Sierra, 2003 Chevrolet Silverado, and 2003 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. From the back of the IP extension remove the 2 retaining bolts from the bracket.
  2. Remove the console assembly from the vehicle. Refer to Console Replacement (Except PRO)   or  Console Replacement (Pro)   . 
  3. Place the console assembly on a work bench.
  4. Disconnect the wire connectors.
  5. Remove the 12V power supply. Refer to 12-Volt Power Supply Replacement   . 
  6. Remove the screws attaching the console to the front extension.
  7. Remove the IP extension from the console.
    Fig 1: Instrument Panel (I/P) Extension (Pro)
    G01579402Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.