Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 636 (INSTRUMENT PANEL, GAGES, AND CONSOLE)REPAIR INSTRUCTIONSCONSOLE REPLACEMENT (PRO)INSTALLATION PROCEDURE
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6
Installation Procedure
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Installation Procedure
WARNING: This page is about a different car, the 2003 GMC Sierra, 2003 GMC Cab & Chassis Sierra, 2003 Chevrolet Silverado, and 2003 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Place the console on the bracket.
- Connect all the wire connectors.NOTE: Refer to FASTENER NOTICE .
- Install the 6 console retaining bolts (1) to the I/P extension.
Tighten
Tighten the 6 retaining bolts to 1.6 N.m (14 lb in).
- Install the console lid and bin assembly. Refer to Console Storage Bin Replacement (Expect Pro) or Console Storage Bin Replacement (Pro) .
- Install the cupholder assembly. Refer to Cupholder Replacement (Luxury) or Cupholder Replacement (Non-Luxury) or Cupholder Replacement (Rear) or Cupholder Replacement (Pro) .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.