Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 207 (STARTING SYSTEM)DIAGNOSTIC INFORMATIONDTC P0563TESTING
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6
DTC P0563: Testing
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Testing
WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
- Did you perform the DIAGNOSTIC SYSTEM CHECK - ENGINE ELECTRICAL? If so, go to next step. If not, go to DIAGNOSTIC SYSTEM CHECK - ENGINE ELECTRICAL .
- Install a scan tool. Start the engine. With a scan tool, monitor the DTC INFORMATION for DTC P0562 in ENGINE CONTROLS. Does the scan tool indicate that DTC P0562 has passed? If so, go to INTERMITTENTS . If not, go to next step.
- Install a scan tool. Turn ON the ignition, with the engine OFF. With a scan tool, observe the IGNITION 1 SIGNAL parameter in the PCM data list. Does the scan tool indicate that the Ignition 1 Signal parameter is less than the specified range of 18.0V? If so, go to step 5 . If not, go to next step.
- Measure the voltage at the battery and compare it with the Ignition 1 Signal parameter in the PCM data list. Are the battery voltage and PCM Ignition 1 readings different by more than the value specified of 0.5V? If so, go to next step. If not, go to TEST A: CHARGING SYSTEM TEST in CHARGING SYSTEM article in ELECTRICAL.
- Replace the PCM. POWERTRAIN CONTROL MODULE in REMOVAL, OVERHAUL & INSTALLATION article in ENGINE PERFORMANCE. After replacement is complete, go to next step.
- Review and record the scan tool Fail Records data. Use the scan tool in order to clear the DTC(s). Operate the vehicle within the Conditions for Running the DTC as specified in the supporting text. See CONDITIONS FOR RUNNING THE DTC . Using the scan tool, observe the SPECIFIC DTC INFORMATION for DTC P0563 until the test runs. Does the scan tool indicate that DTC P0563 failed this ignition? If so, go to step 3 . If not, then system is okay.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.