SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1047 (TRANSFER CASE - MP 1625/1626-NQF)COMPONENT LOCATORTRANSFER CASE CONTROL CONNECTORSTRANSFER CASE ENCODER MOTOR
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6

Transfer Case Encoder Motor

2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Transfer Case Encoder Motor
WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Transfer Case Encoder Motor Connector End View
GM646372Courtesy of GENERAL MOTORS CORP.
Transfer Case Encoder Motor Connector Parts Information

Connector Part Information 
  • OEM: 15326654
  • Service: 88986254
  • Description: 8-Way F GT 280 Sealed 5.8 (BK)
Terminal Part Information 
  • Pins: A, D
  • Terminal/Tray: 15304720/19
  • Core/Insulation Crimp: 4/5
  • Release Tool/Test Probe: 15315247/J-35616-4A (PU)
  • Pins: E-H
  • Terminal/Tray: 15304719/19
  • Core/Insulation Crimp: E/5
  • Release Tool/Test Probe: 15315247/J-35616-4A (PU)
Transfer Case Encoder Motor Connector Terminal Identification

Pin Wire Color Circuit No. Function
A 3 TN 1552 Motor Control A
B-C - - Not Used
D 3 OG 1553 Motor Control B
E 0.35 L-GN/D-BU 7473 Incremental Encoder Impulse Signal
F 0.35 YE 7474 Incremental Encoder Direction Signal
G 0.35 WH/GN 7475 Incremental Encoder Sensor (8V) Supply
H 0.35 PU 7476 Low Reference
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.