Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2006COBALT SS, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 762 (VSA (VEHICLE STABILITY ASSIST) SYSTEM COMPONENTS)WHEEL SPEED SENSOR REPLACEMENTREAR

2006 Chevrolet Cobalt SS, 4D Sedan, Standard

Wheel Speed Sensor Replacement: Rear

2006 Chevrolet Cobalt SS, 4D Sedan, StandardSECTION Rear

WARNING: This page is about a different car, the 2011 Honda Insight and 2010 Honda Insight. However, it is still accessible from the selected car via links, so may be relevant.

Turn the ignition switch to LOCK (0).
Remove the rear wheels.
Release the connector holding clamps (A), then disconnect the wheel sensor connector (B).

Fig 1: Connector Holding Clamps And Wheel Sensor Connector With Torque Specifications
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Remove the clip (C) and the grommets (D).
Remove the bolt and the wheel speed sensor (E).
Install the wheel speed sensor in the reverse order of removal, and note these items:
- Do not twist the sensor wires.
- If the wheel speed sensor comes in contact with the hub bearing unit, it is faulty.
- Make sure the grommet is installed properly.
- Make sure there is no debris in the sensor mounting hole.
Start the engine, and make sure the ABS and the VSA indicators go off.
Test-drive the vehicle, and make sure the ABS and the VSA indicators do not come on.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.