SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006COBALT SS, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 187 (ANTILOCK BRAKE SYSTEM AND TRACTION CONTROL SYSTEM)REPAIR INSTRUCTIONSBRAKE PRESSURE MODULATOR VALVE (BPMV) BRACKET REPLACEMENTINSTALLATION PROCEDURE
2006 Chevrolet Cobalt SS, 4D Sedan, Standard

Installation Procedure

2006 Chevrolet Cobalt SS, 4D Sedan, StandardSECTION Installation Procedure
WARNING: This page is about a different car, the 2005 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of BPMV Bracket
    GM890992Courtesy of GENERAL MOTORS CORP.
  1. Install the BPMV assembly bracket to the vehicle.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the brake pressure modulator assembly bracket mounting bolts and nut.

    Tighten:  Tighten the bolts and nut to 10 N.m (89 lb. in.).

    3. Fig 2: Removing/Installing Brake Modulator Assembly To The Bracket
    GM927841Courtesy of GENERAL MOTORS CORP.
  3. Install the brake modulator assembly to the bracket.
  4. Tighten the 2 brake pressure modulator assembly insulator nuts.

    Tighten:  Tighten the nuts to 10 N.m (89 lb. in.).

    5. Fig 3: Disconnecting/Connecting Electrical Connector From Electronic Brake Control Module (EBCM)
    GM927847Courtesy of GENERAL MOTORS CORP.
  5. Connect the EBCM electrical connector.
    6. Fig 4: View Of Transmission Control Module
    GM927845Courtesy of GENERAL MOTORS CORP.
  6. Reposition the TCM, if equipped, to the mounting bracket.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.