SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006CHEVY EXPRESS G2500, VAN CARGO, 6.6 2REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 941 (ENGINE CONTROL SYSTEM & FUEL SYSTEM - 6.6L (LMM) - INTRODUCTION (2 OF 2))REPAIR INSTRUCTIONSCAMSHAFT POSITION SENSOR REPLACEMENT
2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2

Camshaft Position Sensor Replacement

2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2SECTION Camshaft Position Sensor Replacement
WARNING: This page is about a different car, the 2007 GMC Savana Special, 2007 GMC Savana Camper Special, 2007 GMC Savana, and 2007 Chevrolet Chevy Express. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Camshaft Position Sensor
GM1731581Courtesy of GENERAL MOTORS CORP.
Camshaft Position Sensor Replacement

Callout Component Name

Preliminary Procedures
1 Camshaft Position Sensor Electrical Connector
2 Camshaft Position Sensor Bolt
NOTE: Refer to Fastener Notice .

Tighten:  10 N.m (89 lb in)
3 Camshaft Position Sensor
Procedure: 
Lubricate the camshaft position sensor O-ring with engine oil prior to installation
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.