SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006CHEVY EXPRESS G2500, VAN CARGO, 6.6 2REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 941 (ENGINE CONTROL SYSTEM & FUEL SYSTEM - 6.6L (LMM) - INTRODUCTION (2 OF 2))COMPONENT LOCATORENGINE CONTROLS CONNECTORSMASS AIR FLOW (MAF)/INTAKE AIR TEMPERATURE (IAT) SENSOR
2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2

Mass Air Flow (MAF)/Intake Air Temperature (IAT) Sensor

2006 Chevrolet Chevy Express G2500, Van Cargo, 6.6 2SECTION Mass Air Flow (MAF)/Intake Air Temperature (IAT) Sensor
WARNING: This page is about a different car, the 2007 GMC Savana Special, 2007 GMC Savana Camper Special, 2007 GMC Savana, and 2007 Chevrolet Chevy Express. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Mass Air Flow (MAF)/Intake Air Temperature (IAT) Sensor Connector End View
GM1399241Courtesy of GENERAL MOTORS CORP.
Mass Air Flow (MAF)/Intake Air Temperature (IAT) Sensor Connector & Terminal Parts Information

Connector Part Information 
  • OEM: 15443141
  • Service: See Catalog
  • Description: 5-Way F TS Series, Sealed (BK)
Terminal Part Information 
  • Terminal/Tray: See Terminal Repair Kit
  • Core/Insulation Crimp: See Terminal Repair Kit
  • Release Tool/Test Probe: See Terminal Repair Kit
Mass Air Flow (MAF)/Intake Air Temperature (IAT) Sensor Terminal Identification

Pin Wire Color Circuit No. Function
1 YE 492 MAF Sensor Signal
2 GY/BK 2931 Low Reference
3 PK 139 Ignition 1 Voltage
4 TN 552 Low Reference
5 TN 472 IAT Sensor 1 Signal
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.