Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2003VENTURE BASE, VAN CARGO EXTENDEDREPAIR AND DIAGNOSISRESTRAINTSAIR BAG, SRSSUPPLEMENTAL INFLATABLE RESTRAINT SYSTEMDISABLING & ACTIVATING AIR BAG SYSTEMACTIVATING SYSTEMZONE 7
2003 Chevrolet Venture Base, Van Cargo Extended
Zone 7
2003 Chevrolet Venture Base, Van Cargo ExtendedSECTION Zone 7
- Ensure ignition is off and key is removed. Connect driver side impact air bag module and seat belt pretensioner connectors. See Figure. Install Connector Position Assurance (CPA) clips.
- Install SDM (15-amp) fuse located on right side of instrument panel. Install fuse block cover.
- Staying well away from air bag modules, turn ignition on. Check system for proper operation. See SYSTEM OPERATION CHECK .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.