Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2003TRAILBLAZER 4.2 S, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 980 (SEAT SYSTEM)
2003 Chevrolet TrailBlazer 4.2 S, 4WD
Section 980 (Seat System)
2003 Chevrolet TrailBlazer 4.2 S, 4WDSECTION Section 980 (Seat System)
WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Specifications
- Schematic and Routing Diagrams
- Component Locator
- Diagnostic Information and Procedures
- Diagnostic Starting Point - Seats
- Diagnostic System Check - Power Seat Systems
- Scan Tool Data List
- Scan Tool Data Definitions
- Diagnostic Trouble Code (DTC) List
- DTC B1770, B1775, B1780, B1785, B1790, B1805, or B2415: Seat Motor(s) Overcurrent
- DTC B1825: Seat Recline Position Sensor Circuit
- DTC B1850, B1860, B1960, B2355, B2365, or B2375: Seat Position Sensor Circuit
- DTC B2425 or B2430: Seat Heater Circuit
- DTC B2435 or B2440: Seat Back Heater Sensor Circuit
- DTC B3941: Front Seat Heaters Circuit
- DTC B3962: Seat Motor(s) Overcurrent
- Symptoms - Seats
- Power Seat Inoperative (with memory)
- Power Seat Inoperative (w/o Memory)
- Power Seat Does Not Move Forward/Rearward (with memory)
- Power Seat Does Not Move Forward/Rearward (w/o Memory)
- Power Seat Does Not Tilt Forward (with Memory)
- Power Seat Does Not Tilt Forward (w/o Memory)
- Power Seat Does Not Tilt Rearward (with Memory)
- Power Seat Does Not Tilt Rearward (w/o Memory)
- Power Seat Does Not Recline (with Memory)
- Power Seat Does Not Recline (w/o Memory)
- Memory Seat Feature Inoperative
- Lumbar Support Inoperative (with Memory)
- Lumbar Support Inoperative (w/o Memory)
- Heated Seat Always On
- Heated Seat Inoperative
- Seat - Manual Adjuster Does Not Unlock
- Seat - Manual Adjuster Does Not Lock
- Seat - Hard to Move Forward and Rearward
- Repair Instructions
- Seat Replacement - Front Bucket
- Seat Replacement - Center
- Seat Cushion Frame Replacement - Front
- Seat Cushion Trim Cover and Pad Replacement
- Seat Back Cover and Pad Replacement - Front
- Seat Back Frame Replacement - Front
- Seat Back Hinge/Recliner Mechanism Replace - Front
- Seat Back Recliner Handle Replacement - Front
- Lumbar Replacement - Front Seat
- Lumbar Switch Replacement
- Seat Adjuster Replacement - Front (Manual)
- Seat Adjuster Replacement - Front (Power)
- Seat Adjuster Track Cover Replacement - Front
- Seat Adjuster Motor Replacement - Front
- Seat Switch Replacement - Power
- Seat Switch Bezel Replacement
- Memory Seat Switch Replacement
- Memory Seat Control Module Replacement
- Memory Seat Calibration Procedure
- Heated Seat Switch Replacement - Front
- Seat Back Heater Element Replacement - Front
- Seat Cushion Heater Element Replacement - Front
- Head Restraint Replacement
- Head Restraint Retainer Replacement - Front Seat
- Armrest Replacement - Front Seat
- Cupholder Replacement - Front Seat
- Trim Panel Replacement - Front Seat
- Seat Replacement - Rear (Extended Cab w/4th Door)
- Seat Replacement - Rear (Extended Cab)
- Seat Replacement - Rear (60/40 Split)
- Seat Cushion Frame Replacement - Rear
- Seat Cushion Cover and Pad Replacement - Rear
- Seat Back Cover and Pad Replacement - Rear
- Seat Back Frame Replacement - Rear
- Seat Back Latch Replacement - Rear
- Heated Seat Switch Replacement - Rear
- Armrest Replacement - Rear Seat (60/40 Split)
- Description and Operation
- Special Tools and Equipment
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.