Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2003TRAILBLAZER 4.2 S, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1420 (THEFT DETERRENT SYSTEM)DIAGNOSTIC INFORMATION AND PROCEDURESDTC B2955: SECURITY SYSTEM SENSOR DATA CIRCUITCONDITIONS FOR CLEARING THE MIL/DTC
2003 Chevrolet TrailBlazer 4.2 S, 4WD
Conditions for Clearing the MIL/DTC
2003 Chevrolet TrailBlazer 4.2 S, 4WDSECTION Conditions for Clearing the MIL/DTC
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
- The DTC will clear once an ignition cycle occurs without the fault recurring.
- The BCM history coded will clear once 100 concurrent ignition cycles occur without the fault recurring.
- Using a scan tool.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.