Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2003TRAILBLAZER 4.2 S, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1420 (THEFT DETERRENT SYSTEM)
2003 Chevrolet TrailBlazer 4.2 S, 4WD
Section 1420 (Theft Deterrent System)
2003 Chevrolet TrailBlazer 4.2 S, 4WDSECTION Section 1420 (Theft Deterrent System)
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
- Schematic and Routing Diagrams
- Component Locator
- Diagnostic Information and Procedures
- Diagnostic Starting Point - Theft Deterrent
- Diagnostic System Check - Theft Deterrent
- Scan Tool Data List
- Scan Tool Data Definitions
- Diagnostic Trouble Code (DTC) List
- DTC B2945: Security System Sensor Power Circuit
- DTC B2955: Security System Sensor Data Circuit
- DTC B2960: Sec Sys Sensor Data Incorrect but Valid
- DTC B3033: Security System Indicates Tamper
- DTC P1626: Theft Deterrent Fuel Enable Signal Not Received
- DTC P1630: Theft Deterrent Learn Mode Active
- DTC P1631: Theft Deterrent Start Enable Signal Not Correct
- DTC P1632: Theft Deterrent Start Disable Signal Received
- Symptoms - Theft Deterrent
- Content Theft Deterrent (CTD) Alarm Mode Inoperative
- Content Theft Deterrent (CTD) Does Not Disarm with Key Lock
- Horn Inoperative in Content Theft Deterrent (CTD) Alarm Mode
- Lights Inoperative in Content Theft Deterrent (CTD) Alarm Mode
- Security Indicator Always On or Flashing
- Security Indicator Inoperative
- Repair Instructions
- Theft Systems Description and Operation
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.