Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2003EXPRESS 1/2 TON VAN V6-4.3L VIN XREPAIR AND DIAGNOSISTRANSMISSION AND DRIVETRAINAUTOMATIC TRANSMISSION/TRANSAXLESERVICE AND REPAIRPROCEDURES4L80-E/4L85-E AUTOMATIC TRANSMISSIONVENT HOSE
2003 Chevrolet Express 1/2 Ton Van V6-4.3L VIN X
Vent Hose
2003 Chevrolet Express 1/2 Ton Van V6-4.3L VIN XSECTION Vent Hose
Vent Hose
Removal Procedure
1. Remove the vent hose clip.
2. Remove the vent hose from the transmission vent.
Installation Procedure
1. Install the vent hose to the transmission.
2. Install the vent hose to the clip.
Notice: Refer to Fastener Notice in Service Precautions.
3. Install the bolt and the clamp.
^ Tighten the bolt to 10 Nm (89 inch lbs.).
Removal Procedure
1. Remove the vent hose clip.
2. Remove the vent hose from the transmission vent.
Installation Procedure
1. Install the vent hose to the transmission.
2. Install the vent hose to the clip.
Notice: Refer to Fastener Notice in Service Precautions.
3. Install the bolt and the clamp.
^ Tighten the bolt to 10 Nm (89 inch lbs.).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.