Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Powertrain Control Module (PCM)
Current Gear: Displays current gear position of the transmission
TCC Brake Switch: Displays ON or OFF status of the TCC Brake switch.
TR Sw. A/B/C/P: Displays LOW or HI for the state of each of the four inputs from the IMS. LOW displayed indicates a low voltage signal (0 volts) being monitored at the PCM. Hi displayed indicates a high voltage signal (B+) being monitored at the PCM.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.