Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1997CHEVY EXPRESS G3500, VAN CARGO, 6.5 FREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 89 (MEMORY SYSTEM)SYSTEM TESTSLEFT SEAT DOES NOT MANUALLY MOVE IN ANY DIRECTION
1997 Chevrolet Chevy Express G3500, Van Cargo, 6.5 F
Left Seat Does Not Manually Move In Any Direction
1997 Chevrolet Chevy Express G3500, Van Cargo, 6.5 FSECTION Left Seat Does Not Manually Move In Any Direction
WARNING: This page is about a different car, the 1998 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
After repair or component replacement is completed, perform appropriate MEMORY SYSTEM CHECK under TROUBLE SHOOTING
to verify system is functioning properly.
- Perform POWER SEAT MEMORY SYSTEM CHECK under TROUBLE SHOOTING. Go to next step.
- Turn ignition switch to OFF position. Connect fused jumper to ground and memory seat/mirror diagnostic connector, located under driver's seat. Memory seat/mirror module will chime once to indicate Mode 1 has been entered. Operate driver's seat switch in all positions. Memory seat/mirror module should chime once at each switch input. If any seat switch positions caused memory seat/mirror module chime to sound, go to next step. If any seat switch position did not cause memory seat/mirror module to sound, go to LEFT SEAT DOES NOT MANUALLY MOVE IN ONE DIRECTION and diagnose each suspect switch individually.
- Disconnect left seat switch Gray, 12-pin connector. Using DVOM, check voltage between left seat switch harness connector terminal "B" (Orange/Black wire) and ground. See Fig 1 . If 10-15 volts exists, go to next step. If 10-15 volts does not exist, go to step 8).
- Using DVOM, check voltage between left seat switch harness connector terminals "B" (Orange/Black wire) and "D" (Black wire). If 10-15 volts exists, go to next step. If 10-15 volts does not exist, go tostep 9).
- Briefly connect fused jumper wire between left seat switch harness connector terminals "B" (Orange/Black wire) and "L" (Tan wire) If left seat moves forward, go to step 7). If left seat does not move forward, go to next step.
- Replace memory seat/mirror module. See MEMORY SEAT/MIRROR MODULE under REMOVAL & INSTALLATION. Recheck system operation.
- Replace left seat switch. See POWER SWITCHES under REMOVAL & INSTALLATION. Recheck system operation.
- Repair open or short to ground in Orange/Black wire between left seat switch and slice S211. Recheck system operation.
- Repair open in Black wire between left seat switch and ground. Recheck system operation.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.