SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCADILLAC2013ESCALADE ESV PLATINUM, RWDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTINFOTAINMENTCELLULAR SYSTEM, ENTERTAINMENT SYSTEM, AND NAVIGATION SYSTEMREPAIR INSTRUCTIONSRADIO ANTENNA CABLE EXTENSION CABLE REPLACEMENT (AVALANCHE/ESCALADE EXT)
2013 Cadillac Escalade ESV Platinum, RWD

Radio Antenna Cable Extension Cable Replacement (Avalanche/Escalade EXT)

2013 Cadillac Escalade ESV Platinum, RWDSECTION Radio Antenna Cable Extension Cable Replacement (Avalanche/Escalade EXT)
Fig 1: View Of Radio Antenna Extension Cable Assembly
GM1697390Courtesy of GENERAL MOTORS COMPANY
Radio Antenna Cable Extension Cable Replacement (Avalanche/Escalade EXT)

Callout Component Name

Preliminary Procedure

  1. Remove the instrument panel upper trim pad. Refer to Instrument Panel Upper Trim Panel with Windshield Defroster Nozzle Grille Replacement (Cadillac) , Instrument Panel Upper Trim Panel with Windshield Defroster Nozzle Grille Replacement (Except Cadillac) .
  2. Remove the radio. Refer to Radio Replacement (Except Cadillac) , Radio Replacement (Cadillac) .
  3. Remove the instrument panel center trim panel. Refer to Instrument Panel Center Trim Panel Replacement (Cadillac) , Instrument Panel Center Trim Panel Replacement (Except Cadillac) .
1 Radio Antenna Extension Cable Assembly
  • Disconnect the extension cable from the antenna.
  • Disconnect the extension cable from the radio.
  • Disconnect the extension cable from the center HVAC duct.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.