SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCADILLAC2013CTS V, 2D COUPE, AUTOMATIC TRANSREPAIR AND DIAGNOSISBODY & FRAMEWINDOWSFIXED AND MOVEABLE WINDOW SYSTEMREPAIR INSTRUCTIONSREAR SIDE DOOR WINDOW REGULATOR MOTOR REPLACEMENT
2013 Cadillac CTS V, 2D Coupe, Automatic Trans

Rear Side Door Window Regulator Motor Replacement

2013 Cadillac CTS V, 2D Coupe, Automatic TransSECTION Rear Side Door Window Regulator Motor Replacement
Fig 1: Rear Side Door Window Regulator Motor & Bolts
GM1960149Courtesy of GENERAL MOTORS COMPANY
Rear Side Door Window Regulator Motor Replacement

Callout Component Name

Preliminary Procedure

  1. Remove the rear door trim panel. Refer to Rear Side Door Trim Panel Replacement (Sedan, Wagon) .
  2. Remove the rear side door window regulator. Refer to Rear Side Door Window Regulator Replacement .
1 Rear Side Door Window Regulator Motor Bolts (Qty: 3)
CAUTION:

Refer to Fastener Caution .

Procedure

  1. Using the power window switch, lower the window regulator about 1/2 way down.
  2. Disconnect the electrical connector from the power window motor.

Tighten 
Tighten the bolt (1,2,3) to 9 N.m (80 lb in).
2 Rear Side Door Window Regulator Motor

Procedure

  1. The bolts are located on the back side of the window regulator.
  2. Remove the tape from the window.
  3. Start the vehicle to ensure maximum power to the window motor. This is required to fully seat the window for adjustment.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.