SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCADILLAC2013CTS V, 2D COUPE, AUTOMATIC TRANSREPAIR AND DIAGNOSISBODY & FRAMEWINDOWSFIXED AND MOVEABLE WINDOW SYSTEMREPAIR INSTRUCTIONSREAR SIDE DOOR WINDOW REGULATOR REPLACEMENT
2013 Cadillac CTS V, 2D Coupe, Automatic Trans

Rear Side Door Window Regulator Replacement

2013 Cadillac CTS V, 2D Coupe, Automatic TransSECTION Rear Side Door Window Regulator Replacement
Fig 1: Rear Side Door Window Regulator & Bolts
GM1959978Courtesy of GENERAL MOTORS COMPANY
Rear Side Door Window Regulator Replacement

Callout Component Name
Preliminary Procedure 
Remove the rear door trim panel. Refer to Rear Side Door Trim Panel Replacement (Sedan, Wagon) .
1 Rear Side Door Window Regulator Bolts (Qty: 4)
CAUTION:

Refer to Fastener Caution .

Procedure

  1. Remove the water deflector.
  2. Tape the window in the full up position.
  3. Connect the door trim panel wire harness connector.
  4. Loosen the window regulator to window clamp nuts 4 revolutions. Refer to Rear Side Door Window Replacement .
  5. Using the power window switch, lower the window regulator about 1/2 way down.
  6. Disconnect the electrical connector from the power window motor.

Tighten 
Tighten the bolt (1,2,3) to 9 N.m (80 lb in).
2 Rear Side Door Window Regulator

Procedure

  1. Remove the tape from the window.
  2. Start the vehicle to ensure maximum power to the window motor. This is required to fully seat the window for adjustment.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.