Rear Side Door Window Replacement

2011 Cadillac Escalade Base, AWDSECTION Rear Side Door Window Replacement
Fig 1: Rear Side Door Window
GM1673175Courtesy of GENERAL MOTORS CORP.
Rear Side Door Window Replacement

Callout Component Name
WARNING:

Refer to SIR Warning .

Preliminary Procedures

  1. Disable the supplemental inflatable restraint (SIR) system. Refer to SIR Disabling and Enabling .
  2. Position the rear door window approximately half way down in the door.
  3. Remove the rear door trim panel. Refer to Rear Side Door Trim Panel Replacement (Extended Wheelbase) , Rear Side Door Trim Panel Replacement (Standard Wheelbase) .
  4. Remove the rear door water deflector. Refer to Rear Side Door Water Deflector Replacement .
  5. Remove the rear door weatherstrip. Refer to Rear Side Door Window Weatherstrip Replacement .
1 Rear Door Window Bolt (Qty: 2)
CAUTION:

Refer to Fastener Caution .


Procedure 
Loosen the 2 bolts that attach the window to the window regulator.
Tighten 
7 N.m (61 lb in)
2 Rear Door Window
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.