SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK2019ENVISION BASEREPAIR AND DIAGNOSISBODY & FRAMEEXTERIOR/INTERIOR TRIMEXTERIOR TRIMREPAIR INSTRUCTIONSREAR END SPOILER REPLACEMENT
2019 Buick Envision Base

Rear End Spoiler Replacement

2019 Buick Envision BaseSECTION Rear End Spoiler Replacement
GM3924326Courtesy of GENERAL MOTORS COMPANY
Callout Component Name

Preliminary Procedures

  1. Open and support the liftgate.
  2. Liftgate Upper Trim Finish Panel Replacement
  3. Liftgate Side Sensor Replacement
1 Rear End Spoiler Bolt [6x]
CAUTION:

Refer to Fastener Caution .


Tighten 
2 N.m (17 lb in)
2 Rear End Spoiler Nut [4x]
Tighten 
5 N.m (44 lb in)
3 Rear End Spoiler

Procedure

  1. Using the appropriate tool, release the 2 rear end spoiler retainers.
  2. Disconnect the electrical connector.
  3. Disconnect the rear window washer hose from the rear window washer nozzle.
  4. Remove the rear end spoiler.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.