SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK2019ENVISION BASEREPAIR AND DIAGNOSISBODY & FRAMEEXTERIOR/INTERIOR TRIMINTERIOR TRIM AND PANELINGREPAIR INSTRUCTIONSLIFTGATE UPPER TRIM FINISH PANEL REPLACEMENT
2019 Buick Envision Base

Liftgate Upper Trim Finish Panel Replacement

2019 Buick Envision BaseSECTION Liftgate Upper Trim Finish Panel Replacement
GM3924891Courtesy of GENERAL MOTORS COMPANY
Callout Component Name
1 Liftgate Upper Trim Finish Panel

Procedure

  1. Use the appropriate trim tool to release the liftgate upper trim finish panel and the liftgate lower trim finish panel from the liftgate inner panel as one assembly.
  2. Separate the liftgate upper trim finish panel from the lower trim finish panel by releasing the tabs on each side.
  3. Disconnect the electrical connector.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.