SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK2016ENCLAVE CONVENIENCEREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTINTERIOR/EXTERIOR TRIMINSTRUMENT PANEL AND CONSOLE TRIMREPAIR INSTRUCTIONSINSTRUMENT PANEL LOWER TRIM PANEL REPLACEMENT
2016 Buick Enclave Convenience

Instrument Panel Lower Trim Panel Replacement

2016 Buick Enclave ConvenienceSECTION Instrument Panel Lower Trim Panel Replacement
Fig 1: Instrument Panel Lower Trim Panel
GM2884386Courtesy of GENERAL MOTORS COMPANY
Callout Component Name

Preliminary Procedures

  1. Remove the instrument panel upper trim pad. Refer to Instrument Panel Trim Pad Replacement (Acadia w/RPO UV6) Instrument Panel Trim Pad Replacement (Acadia w/o RPO UV6) Instrument Panel Trim Pad Replacement (Enclave) Instrument Panel Trim Pad Replacement (Traverse) .
  2. Remove the front floor console. Refer to Front Floor Console Replacement (Acadia) Front Floor Console Replacement (Enclave) Front Floor Console Replacement (Traverse) .
  3. Remove the steering column assembly. Refer to Steering Column Replacement .
  4. Remove the hood primary latch release cable handle. Refer to Hood Primary Latch Release Cable Handle Replacement (Acadia, Enclave, Traverse) .
1 Instrument Panel Lower Trim Panel Bolt (Qty: 6)
CAUTION:

Refer to Fastener Caution .


Tighten 
9 N.m (80 lb in)
2 Instrument Panel Lower Trim Panel Bolt (Qty: 20)
3 Instrument Panel Lower Trim Panel
NOTE:

Prior to removing the lower trim panel from the carrier assembly, note the routing of the wiring harness to ensure proper reinstallation.

Procedure

  1. Disconnect all electrical connections.
  2. With the aid of an assistant, remove the trim panel from the vehicle.
  3. When replacing the instrument panel lower trim panel, transfer all necessary components.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.