SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK2013REGAL TURBO PREMIUM, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 145 (WIPER SYSTEM AND WASHER SYSTEM)REPAIR INSTRUCTIONSWINDSHIELD WASHER SOLVENT CONTAINER REPLACEMENT
2013 Buick Regal Turbo Premium, Standard Trans

Windshield Washer Solvent Container Replacement

2013 Buick Regal Turbo Premium, Standard TransSECTION Windshield Washer Solvent Container Replacement
WARNING: This page is about a different car, the 2012 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Windshield Washer Solvent Container
GM2203359Courtesy of GENERAL MOTORS COMPANY
Windshield Washer Solvent Container Replacement

Callout Component Name

Preliminary Procedures

  1. Remove the windshield washer solvent container fill tube. Refer to Windshield Washer Solvent Container Filler Tube Replacement .
  2. Remove the front LH wheelhouse liner. Refer to Front Wheelhouse Front Liner Replacement .
  3. Disconnect the windshield washer pump and level sensor electrical connectors.
  4. Disconnect the electrical harness from the washer container.
  5. Disconnect the windshield washer pump hose from the pump and the washer container.
1 Windshield Washer Container Nut (Qty: 3)
CAUTION:

Refer to Fastener Caution .


Tighten 
10 N.m (89 lb in)
2 Windshield Washer Solvent Container Assembly

Procedure

  1. Lift the windshield washer container off the three studs securing the container to the vehicle.
  2. Drain the windshield washer solvent from the container into a suitable clean drain pan.
  3. Transfer parts as needed.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.