SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK2013REGAL TURBO PREMIUM, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 145 (WIPER SYSTEM AND WASHER SYSTEM)REPAIR INSTRUCTIONSWINDSHIELD WASHER SOLVENT CONTAINER FILLER TUBE REPLACEMENT
2013 Buick Regal Turbo Premium, Standard Trans

Windshield Washer Solvent Container Filler Tube Replacement

2013 Buick Regal Turbo Premium, Standard TransSECTION Windshield Washer Solvent Container Filler Tube Replacement
WARNING: This page is about a different car, the 2012 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Windshield Washer Solvent Container Filler Tube
GM2203343Courtesy of GENERAL MOTORS COMPANY
Windshield Washer Solvent Container Filler Tube Replacement

Callout Component Name

Preliminary Procedure

  1. Open and support the hood.
  2. Reach into the engine compartment at the windshield washer solvent container fill tube side and grasp the fill tube neck.
  3. With a slight turn and upward pull, remove the fill tube from the top of the windshield washer solvent container.
  4. Inspect the fill tube grommet in the top of the washer container.
1 Windshield Washer Solvent Container Fill Tube

Procedure

  1. Lubricate the end of the fill tube with clean windshield washer solvent prior to installing the fill tube into the top of the windshield washer container.
  2. Slowly press the fill tube neck into the windshield washer container seal.
  3. Ensure the top of the fill tube tab locks into the tab on the front compartment fuse block housing.
  4. Once connected, push downward in order to engage the fill tube.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.