Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSBUICK2006TERRAZA CXL, 3.5 L, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 283 (REAR SUSPENSION SYSTEM)REPAIR INSTRUCTIONSSTRUT ASSEMBLY REPLACEMENTINSTALLATION PROCEDURE

2006 Buick Terraza CXL, 3.5 L, AWD

Installation Procedure

2006 Buick Terraza CXL, 3.5 L, AWDSECTION Installation Procedure

WARNING: This page is about a different car, the 2007 Chevrolet Monte Carlo and 2007 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Care should be taken to avoid chipping or scratching the coating when handling the suspension coil spring. Damage to the coating can cause premature failure.

Install the strut into place.

Fig 1: View Of Strut
Courtesy of GENERAL MOTORS CORP.
Install the strut to knuckle bolts.
Tighten: Tighten the strut to knuckle bolts and nuts to 120 N.m (89 lb ft).

NOTE: Refer to Fastener Notice .
Install the bolt (2) to the brake hose bracket (3) and the strut assembly.
Tighten: Tighten the bolt to 10 N.m (89 lb in).

Fig 2: View Of Brake Hose Bracket & Bolt & Strut Assembly
Courtesy of GENERAL MOTORS CORP.
Connect the stabilizer shaft link to the strut. Refer to Stabilizer Shaft Link Replacement .

Fig 3: View Of Strut-To-Body Mount Nuts & Brake Hose Bracket Bolt
Courtesy of GENERAL MOTORS CORP.
Install the tire and wheel. Refer to Tire and Wheel Removal and Installation .
Install strut to body mount nuts (1).
Tighten: Tighten the strut to body mount nuts to 45 N.m (33 lb ft).
Lower the vehicle.
Adjust the rear wheel alignment. Refer to Wheel Alignment Specifications .

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.