Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBUICK2000PARK AVENUE BASE, 3.8 KREPAIR AND DIAGNOSIS (SINGLE PAGE)ELECTRICALGAUGESINSTRUMENT PANEL - ANALOG
2000 Buick Park Avenue Base, 3.8 K
Instrument Panel - Analog
2000 Buick Park Avenue Base, 3.8 KSECTION Instrument Panel - Analog
- Description
- Operation
- Component Locations
- Trouble Shooting
- Self-Diagnostic System
- Diagnostic Tests
- Notes
- DTC B0530: Fuel Level Sender Stuck
- DTC B0532: Fuel Level Sender Input Shorted To Ground
- DTC B0533: Fuel Level Sender Input Open Or Shorted To Battery Voltage
- DTC B0602: PLL Oscillator Error
- DTC B1510: Air Bag Telltale Fault
- DTC B1520: Reset Switch Stuck/Shorted To Ground
- DTC B1521: Eng/Met Switch Stuck/Shorted To Ground
- DTC B1522: Fuel Info Switch Stuck/Shorted To Ground
- DTC B1523: Gauge Switch Stuck/Shorted To Ground
- DTC B1524: ODO/Trip Switch Stuck/Shorted To Ground
- System Tests
- Notes
- Test A: Abs Indicator Is On
- Test B: Air Bag Indicator Is On
- Test C: Entire IPC Inoperative
- Test D: Fuel Gauge Does Not Operate Properly
- Test E: High Beam Indicator Inoperative
- Test F: High Temperature Indicator Is On
- Test G: Oil Indicator Is On
- Test H: Seat Belt Indicator Is On When Seat Belts Are Fastened
- Test I: Security Indicator Is On
- Test J: Service Engine Soon Indicator Is On
- Test K: Speedometer Does Not Operate Properly
- Test L: Tachometer Does Not Operate Properly
- Test M: Temperature Gauge Does Not Operate Properly
- Test N: TRAC Off Indicator Is On
- Test O: Turn Signal Indicators Inoperative
- Test P: Volts Indicator Is On
- Test Q: Eng/Met Button Inoperative
- Test R: Fuel Info Button Inoperative
- Test S: Gauge Button Inoperative
- Test T: ODO/Trip Button Inoperative
- Test U: Reset Button Inoperative
- Test V: HUD System Always On
- Test W: HUD System Inoperative
- Test X: Dimmer Switch Does Not Vary HUD Image Intensity
- Test Y: HUD Image Does Not Move Up Or Down
- Test Z: HUD Speedometer Does Not Switch Between English And Metric
- Test Aa: HUD Speedometer Inoperative
- Test Ab: HUD Turn Signals And High Beam Indicators Inoperative
- Test Ac: HUD Does Not Dim With Headlights On
- Removal & Installation
- Wiring Diagrams
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.