Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBMW2013128I 2D CONVERTIBLE, ENG CD N52, STANDARD TRANSREPAIR AND DIAGNOSISSUSPENSIONWHEEL ALIGNMENTSTEERING AND WHEEL ALIGNMENT - REPAIRSTEERING COLUMN32 31 082 REMOVING AND INSTALLING/REPLACING STEERING ANGLE SENSOR
2013 BMW 128i 2D Convertible, Eng CD N52, Standard Trans
32 31 082 Removing and installing/replacing steering angle sensor
2013 BMW 128i 2D Convertible, Eng CD N52, Standard TransSECTION 32 31 082 Removing and installing/replacing steering angle sensor
NOTE:
Steering angle sensor is integrated in the steering column stalk fixture
. See 61 31 006 REMOVING AND INSTALLING/REPLACING FIXTURE FOR STEERING COLUMN STALK
.
After installation:
- Replacement only: Carry out programming/coding
- Carry out steering angle sensor adjustment/adjustment for active front steering . See 32 10 005 Adjustment for active front steering and 61 31 996 CARRYING OUT STEERING ANGLE SENSOR ADJUSTMENT .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.