Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBMW2013128I 2D CONVERTIBLE, ENG CD N52, STANDARD TRANSREPAIR AND DIAGNOSISSUSPENSIONWHEEL ALIGNMENTSTEERING AND WHEEL ALIGNMENT - REPAIRELECTRONIC CHASSIS ALIGNMENT32 00... MOVING VEHICLE INTO NORMAL POSITION
2013 BMW 128i 2D Convertible, Eng CD N52, Standard Trans
32 00... Moving vehicle into normal position
2013 BMW 128i 2D Convertible, Eng CD N52, Standard TransSECTION 32 00... Moving vehicle into normal position
Necessary preliminary tasks:
- Check compliance with test conditions , bring vehicle to a stop if necessary.
- Version with air spring system: Carry out ride-height-calibration
- Check vehicle interior and luggage compartment (incl. luggage compartment recess) for load, unload vehicle if necessary
- Introduce DIN load into vehicle
- Determine vehicle ride height
. See 31 33 095 MEASURING RIDE-LEVEL HEIGHT OF VEHICLE
.NOTE: If the vehicle ride height is not inside the tolerance, the vehicle must be repaired (coil spring/leakage).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.