Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBMW2013128I 2D CONVERTIBLE, ENG CD N52, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1009 (FRONT AXLE - REPAIR)
2013 BMW 128i 2D Convertible, Eng CD N52, Standard Trans
Section 1009 (Front Axle - Repair)
2013 BMW 128i 2D Convertible, Eng CD N52, Standard TransSECTION Section 1009 (Front Axle - Repair)
WARNING: This page is about a different car, the 2010 BMW 135i, 2009 BMW 135i, and 2008 BMW 135i. However, it is still accessible from the selected car via links, so may be relevant.
- General
- 00 Danger Of Poisoning If Oil Is Ingested/Absorbed Through The Skin
- 00 Risk Of Injury If Oil Comes Into Contact With Eyes And Skin
- 00 Safety Instructions For Handling Oil
- 00...... Raising Vehicle With Trolley Jack
- 31.... Front Axle Overview
- 31.... Layout Of Spring Strut Shock Absorber
- 31 00... Front Axle + Steering: Wheel/Chassis Alignment Check Must Be Carried Out After The Following Work
- 31 00... Information On Replacing Shock Absorbers
- 31 00... Instructions (Chassis Components Made Of Aluminum)
- 31 00... Notes On Repairing Threads
- Front Axle Suspension
- Front Sub-Frame
- 31 11 001 Replacing Front Axle Carrier
- 31 11 506 Lowering/Raising Front Axle Carrier (Special Tool SWZ00-2040)
- 31 11 506 Lowering/Raising Front Axle Carrier (Universal Lifter)
- 51 61... Removing And Installing/Replacing Protective Skid
- 51 61 011 Removing And Installing/Replacing V-Strut, Front Axle Carrier, Left Or Right
- 51 61 017 Removing And Installing/Replacing Diagonal Strut, Front End, Left
- 51 61 018 Removing And Installing/Replacing Diagonal Strut, Front End, Right
- Struts With Rubber Mounts
- 31 12 000 Removing And Installing/Replacing Left Or Right Control Arm
- 31 12 080 Removing And Installing/Replacing Both Tension Struts
- 31 12 138 Replacing Rubber Mounts On Both Tension Struts
- 31 12 003 Removing and installing / replacing top right wishbone
- 31 12 024 Replace wheel control joint in wishbone (all-wheel drive vehicle)
- 31 12 050 Removing and installing/replacing left or right trailing link
- 31 12 134 Replacing rubber mount in left or right trailing link
- Wheel Bearings And Stub Axle
- Spring Strut
- 31.... Layout Of Spring Strut Shock Absorber
- 31 00... Information On Replacing Shock Absorbers
- 31 31 000 Removing And Installing Complete Left Or Right Spring Strut Shock Absorber
- 31 31 031 Replacing Front Left Or Right Spring Strut Shock Absorber
- 51 71 371 Removing And Installing/Replacing Tension Strut On Left Or Right Spring Strut Dome
- Spring With Suspension
- Stabilizer Bar
- Troubleshooting
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.