Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBMW2010X6 ACTIVEHYBRIDREPAIR AND DIAGNOSISBODY & FRAMETOWING SYSTEMSTRAILERS - REPAIRLOADING PLATFORM86 10... REPLACING POSITION LIGHT
2010 BMW X6 ActiveHybrid
86 10... Replacing position light
2010 BMW X6 ActiveHybridSECTION 86 10... Replacing position light
Unclip cover (1) on side recess (arrow).
Pull flat connector (1) from flat contact.
Pull out cable (1) completely.
CAUTION:
Before drilling out rivet heads, drive in rivet pins with a punch.
Drill out rivet heads (2) and remove position light housing from front.
Drill out rivet heads (2) and remove position light housing from front.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.