Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBMW2009X6 50IREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTDRIVERS ASSISTANCE SYSTEMS - ADASDISTANCE SYSTEMS, CRUISE CONTROL - REPAIRREVERSING CAMERA (RFK), SIDE VIEW CAMERA, TOP VIEW CAMERA66 53 010 CALIBRATING REVERSING CAMERA (FROM 10/2009)
2009 BMW X6 50i
66 53 010 Calibrating reversing camera (from 10/2009)
2009 BMW X6 50iSECTION 66 53 010 Calibrating reversing camera (from 10/2009)
NOTE:
Calibration of reversing camera must be carried out after the following work:
- Removal and installation/replacement of reversing camera
- Body repair work at rear end of vehicle
- Adjustment of rear lid
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.