Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
86 10 ... Disassembly of Rear Apron
Remove rear light, refer to 86 10 ... REPLACING REAR LIGHT .
Remove plastic bush/metal bush, refer to 86 10 ... REMOVING PLASTIC BUSH/METAL BUSH .
Cut through sealing compound (1) on left and right and remove.
Drill out rivets (2) on left and right sides on lower apron edge.
Installation:
Use Sikaflex 221 as sealing compound.
Cut through sealing compound (1) and remove.
Drill out rivets (2).
Installation:
Use Sikaflex 221 as sealing compound.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.