Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBMW2006X5 (E53) V8-4.8L (N62)REPAIR AND DIAGNOSISA L L DIAGNOSTIC TROUBLE CODES ( DTC )TESTING AND INSPECTIONP CODE CHARTSP2103
2006 BMW X5 (E53) V8-4.8L (N62)
P2103
2006 BMW X5 (E53) V8-4.8L (N62)SECTION P2103
2CEF - P2103
Information saved in
DME
Fault code
2CEF - P2103
Fault text
Throttle-valve actuator, activation
Fault description
Throttle Actuator 'A' Control Motor Circuit High
Condition for fault identification
Test condition:
Direct fault report from driver circuit chip in the DME
Terminal condition: Terminal 15=TRUE
Voltage condition:
battery voltage>7 V
Condition for fault memory entry
none
Action in service
Check/replace components and wiring
Fault effect and breakdown warning
Driver information
Warning light:
MIL on in 2nd driving cycle + EPCL
Service instruction
none
Information saved in
DME
Fault code
2CEF - P2103
Fault text
Throttle-valve actuator, activation
Fault description
Throttle Actuator 'A' Control Motor Circuit High
Condition for fault identification
Test condition:
Direct fault report from driver circuit chip in the DME
Terminal condition: Terminal 15=TRUE
Voltage condition:
battery voltage>7 V
Condition for fault memory entry
none
Action in service
Check/replace components and wiring
Fault effect and breakdown warning
Driver information
Warning light:
MIL on in 2nd driving cycle + EPCL
Service instruction
none
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.