Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
61 61 270 Removing and installing complete wiper console
Necessary preliminary tasks:
- Remove COWL PANEL COVER .
- Remove HEATER BULKHEAD .
Unfasten plug connection (1) and disconnect.
Unscrew bolt (2).
Installation:
tightening torque, 61 61 6AZ. Refer to GENERAL ELECTRICAL SYSTEM - TIGHTENING TORQUES .
Installation:
Fit rubber grommet (1) of wiper console on pin (2).
Release nuts and feed out complete wiper console through opening in heater bulkhead.
Installation:
tightening torque, 61 61 5AZ. Refer to GENERAL ELECTRICAL SYSTEM - TIGHTENING TORQUES .
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.