Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBMW2006X3 AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 385 (BODY EQUIPMENT - SPECIAL TOOLS - 5-SERIES (E39))
2006 BMW X3 Automatic
Section 385 (Body Equipment - Special Tools - 5-Series (E39))
2006 BMW X3 AutomaticSECTION Section 385 (Body Equipment - Special Tools - 5-Series (E39))
WARNING: This page does not describe the selected car, but rather 17 other vehicles, including the 2003 BMW M5, 2003 BMW 540i, 2003 BMW 530i, 2003 BMW 525i, and 2002 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.
- Body equipment
- 51 0 010 Test gauge for windscreen and rear window installation
- 51 0 030 Twin cartridge gun
- 51 0 101 Support, right
- 51 0 102 Support, left
- 51 0 103 Bridge
- 51 0 104 Windscreen/rear window locating fixture
- 51 0 105 Side window locating fixture
- 51 0 106 Vacuum pump
- 51 0 107 Hoisting winch
- 51 0 108 Hoisting winch
- 51 0 109 Suction cup
- 51 1 010 Punching fixture
- 51 2 010 Pillar guard (2)
- 51 2 090 Fixture
- 51 2 150 Assembly tool
- 51 2 196 Protection
- 51 2 197 Drift
- 51 3 010 Suction lift (2 x)
- 51 3 040 Fixture
- 51 3 090 Clamping strap
- 51 3 200 Special wrench set
- 51 3 210 Gauge
- 51 3 220 Hand-held suction cup
- 51 4 000 Assembly film
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.