Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBMW2006M6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1655 (ENGINE - REPAIR)
2006 BMW M6
Section 1655 (Engine - Repair)
2006 BMW M6SECTION Section 1655 (Engine - Repair)
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 528xi, 2010 BMW 528i, 2009 BMW 528xi, 2009 BMW 528i, and 2008 BMW 528xi. However, it is still accessible from the selected car via links, so may be relevant.
- 00 Engine, General
- 00 Danger of poisoning if oil is ingested/absorbed through the skin
- 00 Risk of injury if oil comes into contact with eyes and skin
- 00 Safety instructions for handling oil
- 11 00... Engine oil service (N52K)
- 11 00 Removing and installing/replacing acoustic cover (N52/N52K)
- 11 00 050 Removing and installing engine (N52K)
- 11 00 670 Securing engine in installation position (N52, N53)
- Engine identification
- Mounting engine on assembly stand (N52K)
- 12 Cylinder Head With Cover
- Oil Sump
- 14 Housing Cover
- 21 Crankshaft With Bearing
- 22 Flywheel
- 23 Vibration Damper
- 24 Connecting Rod With Bearing
- 25 Piston With Rings And Pin
- V-Ribbed Belt With Tension/Deflection Element
- 31 Camshaft
- 11 31 005 Checking timing of camshaft(s) (N52K)
- 11 31 025 Removing and installing/replacing inlet camshaft (N52K)
- 11 31 028 Removing and installing/replacing exhaust camshaft (N52K)
- 11 31 051 Replacing timing chain (N52K)
- 11 31 090 Installing and removing/replacing chain tensioner piston (N52K)
- 11 31 505 Adjusting timing of camshaft(s) (N52K)
- 33 Rocker Arm With Bearing Mount
- 34 Valves With Springs
- 37 Variable Valve Gear
- Oil Supply
- 41 Oil Pump With Filter And Drive
- 42 Oil Filter And Lines
- 51 Water Pump With Drive
- 53 Thermostat And Connections
- 61 Intake Manifold
- 78 Emission Control, Oxygen Sensor
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.