Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
61 35 127 Removing and installing/replacing body gateway module
Read out PROGRAMMING/CODING .
- Print out and make a note of settings for car and key memory in CKM menu
Necessary preliminary tasks:
- Disconnect NEGATIVE BATTERY CABLE
- Remove TRIM FOR INSTRUMENT PANEL, BOTTOM LEFT (same as right side)
Unclip pin (1) from retaining strap (2).
Unclip pin (1) from shock absorber (2).
Open rotary clips (1) and remove cover (2) in direction of arrow.
Release screws (1).
Pull fuse holder (2) back slightly.
Detach AIRBAG CONTROL UNIT WITH GATEWAY MODULE .
Unlock plug connections (1) and disconnect.
Unlock catches (3) in direction of arrow and remove body module (2) from equipment carrier (4).
Replacement:
Carry out PROGRAMMING/CODING .
- Check printed-out or noted-down settings for car and key memory in CKM menu and reset if necessary
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.