Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Power Supply
The SIM is supplied with voltage KL terminals 30 and ground from KL31. If the vehicle voltage is sufficient then a switching controller is supplied first, which supplies voltage to the intelligent Star Coupler and the power supply.
The second switching controller is supplied by KL 30 during operation and is controlled by the microprocessor via the cable SHDN 2. The capacitor is charged as of KL R.
The charging of the capacitor forms the emergency energy reserve. The capacitor voltage is 33V. (Energy Reserve in the E65 is 400v.)
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.