Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
41 00... Handling Electrical And Electronic Equipment
1.0 Battery
- There is a risk of explosion when welding or grinding work is carried out in the vicinity of the battery. The battery must be removed . Prior to removing the battery, interrogate the fault memories of the control units if necessary.
2.0 Control units
- The following hazards are present when the battery is connected:
- Damage to control units during welding work on the body.
- Accidental triggering of airbags during straightening work on the body.
Due to these potential hazards, it is essential to disconnect the battery negative lead prior to welding and straightening work. Prior to disconnecting the negative lead, interrogate the fault memories of the control units if necessary.
- Control units are designed for a temperature of 65°C. The temperatures in a spraying booth do not pose any problems. If a vehicle is inside the spraying booth at an indicated temperature of 80°C, the actual temperature of the vehicle will be ≤ 60°C (object temperature).
- Protects control units against the effects of heat at temperatures > 65°C (e.g. during welding and drying with an infrared radiator or hot air blower).
3.0 Electric cables and wiring harnesses
- Protect electric cables and wiring harnesses against damage (e.g. during straightening and grinding work).
- Protect electric cables and wiring harnesses against the effects of heat at temperatures > 65°C (e.g. during welding and drying with an infrared radiator or hot air blower).
- Do not kink electric cables.
4.0 Optical fibers
- Follow instructions for handling optical fibers . See 61 00... NOTES ON HANDLING OPTICAL FIBERS .
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.