Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
61 31 203 Replacing Switch Combination For Seat Adjustment
Special tools required:
- 00 9 341
Remove and install center armrest (front) . See 51 16 195 REMOVING AND INSTALLING CENTRE ARMREST (FRONT) .
Release screws (1).
Lever out front center armrest trim (2) with special tool 00 9 341 and remove and direction of arrow.
Disconnect plug connections (1).
Release screws (1).
Feed out switch combination for seat adjustment (2) in direction of arrow.
Installation:
Make sure guides (1) are correctly seated in mountings (2).
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.