Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBMW2006550I AUTOMATICREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTMIRRORSBODY EQUIPMENT - REPAIRGENERAL51 00...NOTES ON COMPONENT BONDING ADHESIVE TAPE4. BONDING
2006 BMW 550i Automatic
4. Bonding
2006 BMW 550i AutomaticSECTION 4. Bonding
4.1 Components without pre-fitted adhesive tape
- Pull off liner* from adhesive tape
- Position adhesive tape on component and stick on
- Press down adhesive tape over entire adhesive area
- Continue with Point 4.2
* Liner is the protective film on the adhesive tape
4.2 Components with pre-fitted adhesive tape
- Pull off liner* from adhesive side (if adhesive area is large, do not pull off liner completely)
- Align component in correct position on vehicle
- Press down component over entire adhesive area
* Liner is the protective film on the adhesive tape
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.