Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
11 37 030 Removing and installing/replacing eccentric shaft sensor (N52)
2006 BMW 525xi AutomaticSECTION 11 37 030 Removing and installing/replacing eccentric shaft sensor (N52)
Necessary preliminary tasks:
- Remove Cylinder Head Cover .
IMPORTANT:
All bolts are secured against falling out, release bolts (2) on cylinder head only but do not
unscrew fully.
Bolts (2) can fall out.
Risk of damage to timing chain drive.
Release screws (2).
Lift out sensor (1).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.