Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBMW2006330XI AUTOMATICREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTCRUISE CONTROL SYSTEMSDISTANCE SYSTEMS, CRUISE CONTROL - REPAIR - E90/E9120 PARK DISTANCE CONTROL66 20 565 REMOVING AND INSTALLING/REPLACING FRONT SIGNAL SENSOR (PARK DISTANCE CONTROL)
2006 BMW 330xi Automatic
66 20 565 Removing and installing/replacing front signal sensor (Park Distance Control)
2006 BMW 330xi AutomaticSECTION 66 20 565 Removing and installing/replacing front signal sensor (Park Distance Control)
Necessary preliminary tasks:
Disconnect plug connection (1).
Unclip signal sensor on both sides from fixture (1).
Installation:
Signal sensor (2) must snap audibly into retaining tabs.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.