Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
13 64 541 Replacing all fuel injectors (S62)
2001 BMW Z8SECTION 13 64 541 Replacing all fuel injectors (S62)
Switch off ignition.
NOTE:
Remove injection pipe.
Fuel lines remain connected.
Refer to 13 53 240 REPLACING COMPLETE INJECTION PIPE (S62) .
Fuel lines remain connected.
Refer to 13 53 240 REPLACING COMPLETE INJECTION PIPE (S62) .
Unclip fasteners.
Detach all fuel injectors from injection pipes.
Installation:
Check O-rings on fuel injectors for damage, replace if necessary.
Coat O-rings with anti-friction rubber coating (e.g. petroleum jelly).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.