Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBMW2001330I AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 65 (STEERING COLUMN)
2001 BMW 330i Automatic
Section 65 (Steering Column)
2001 BMW 330i AutomaticSECTION Section 65 (Steering Column)
WARNING: This page is about a different car, the 2003 BMW X5, 2002 BMW X5, 2001 BMW X5, and 2000 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.
- Identification
- Description & Operation
- Service Precautions
- Adjustments
- Removal & Installation
- Airbag Modules
- Interlock Cable
- Steering Angle Sensor
- Steering Column
- Steering Column Adjuster Gear Motor
- Steering Column Adjuster Shaft
- Steering Column Adjusting Lever
- Steering Column Trim (Lower Section)
- Steering Column Trim (Upper Section)
- Steering Lock
- Steering Lock Cylinder
- Steering Spindle (Lower Section)
- Steering Spindle Sleeve For Lower Section (Assembly Partition Wall)
- Steering Spindle Sleeve For Lower Section (Bulkhead)
- Steering Spindle (Upper Section)
- Steering Spindle Bearing (Lower)
- Steering Spindle Bearing (Upper)
- Steering Spindle Double Joint For Lower Section
- Steering Wheel
- Overhaul
- Torque Specifications
- Special Tools
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.